Crumbler

ALTINBİLEK Crumbler ensure that pelleted products are broken in a perfect balance at every point in desired particle sizes. In pellet presses, it is used to bring the existing pellet to the desired particle size in a balanced way instead of instant die change. Each of the rolls that perform the crushing process are driven at different speeds by separate gearmotors. Coupling and joint connection systems are used for power transmission to the rolls. In order to ensure that the pelleted products are crushed in desired sizes using minimum energy, special tooth structure channels are opened on the roller surfaces and the rollers are subjected to surface hardening heat treatment. Thanks to this design, the pellet is prevented from crushing, and it is ensured to be crushed in granular form by cutting method. Altınbilek Crumbler has an electro-pneumatically controlled cover system in order to control the entry of goods into the system and prevent the accumulation of raw materials on the rolls. There is also an electro-pneumatic controlled by-pass flap system within this section. Thanks to the by-pass system, if deemed necessary, pelleted products can be passed through the granulator without breaking. There is a reducer motor driven drum type feeding system at the entrance. The feeding system is used to ensure a balanced distribution of incoming pelleted products on the roll and to control the inlet flow. The pellet entrance opening can be adjusted in the feeding system. In order to determine the capacity and particle size in the crushing process, it is possible to adjust the gap between the rolls. A spring system is applied to prevent damage to the rolls and system. There is a wide observation and control cover on each roll group and sampling apparatus at the exit. Thus, the entire flow from the incoming pellet to the granulated product can be observed and controlled easily. Altınbilek Granulators offer manual and automatic roll gap adjustment options to their operators.